Humax 5400

[Gast]

Hallo,<p>Ik heb een oude model Humax 5400.

Ik wil hem pathcen met ver allcam 3.2a.

Ik heb namelijk helemaal geen verstand van patchen

Kan iemand mij uitleggen hoe ik dat moet doen?

Met welke software en kabel?

Mail mij..

Alvast bedankt

Ert.

[Gast]

HOW TO INSTALL THE +CAM FIRMWARE INTO YOUR HUMAX 5400 SERIES

1. Download the Humax Control Centre software from our software section (password=humax2000)

2. Open the Humax Control Centre software

3. Turn off your Humax (so put it in standby modus)

4. Select firmware and select the +CAM firmware where you have stored it

5. Screen opens and asks you to turn on your Humax

6. Turn on your Humax and you see a progress bar

7. After 100% a screen opens and tells you to turn on your Humax

8. Turn on your Humax and now you are working with the +CAM firmware

<p>

HOW TO INSTALL THE SATELLITE SETTINGS INTO YOUR HUMAX 5400 SERIES

1. Download the Humax Control Centre software from our software section (password=humax2000)

2. Open the Humax Control Centre software

3. Turn off your Humax (so put it in standby modus)

4. Select HNF File and select the satellite settings file where you have stored it

5. Screen opens and asks you to turn on your Humax

6. Turn on your Humax and you see a progress bar

7. After 100% a screen opens and tells you to turn on your Humax

8. Turn on your Humax and now you are working with the new satellite settings

<p>

ZEROMODEM CABLE LAYOUT

For connecting your Humax with your PC you need a zero modem cable

[Gast]

Standby is voldoende!

[Gast]

<blockquote><font size="1" face="Verdana, Helvetica, sans-serif">citaat:</font><hr>Onderwerp gestart door Chivato:

<strong>2. Open the Humax Control Centre software

</strong><hr></blockquote><p>Is het niet zo dat je hem uit moet zetten met de schakelaar achterop de Humax ? Of kan het inderdaad ook met stand-by ?