Gast Geplaatst: 21 oktober 2003 Delen Geplaatst: 21 oktober 2003 Juul ik vond nog iets op SatDudez wat je evt ook kunt proberen. **************************************** vraag: Tried a new set of channel listings and NOW I really do have problems. I pulled the data cable from the stb by accident whilst uploading and now the stb display shows on connection:- 9500 0 5-01 6-01 6-01 6-02 6-03 Antwoord: a) I still think that the problem is a bad channel file, so you need to clear the channel memory some how... If you reflash the firmware this may also clear the channel memory, but you MUST read up in this forum how to do this correctly or you will have very big problems ! I found by "accident" that when the Sammy boots (power OFF/ON at the back) if you press (may need to hold ?) the POWER button on the front of the unit, its does a full factory reset !!!!!!!!!!!! Then all you see is a TV-screen asking you what language do you want to use ! I not sure at what stage you do this, maybe its before or after the "9500" is displayed ????? Anyway you have nothing to lose, so give it a try... BUT, before you do this ensure the Sammy is NOT connected to the PC !!!!!!! As this can cause the problems you have been seeing. Link naar reactie Delen op andere sites Meer opties om te delen...
Gast Geplaatst: 24 oktober 2003 Delen Geplaatst: 24 oktober 2003 Beste Erik alle pogingen zijn en blijven negatief. gisteren de lokale sat-leverancier benaderd - helaas geen resultaat. is er nog een andere, laatste, mogelijkheid ? heb iets gezien over jtag ? hoor graag groetjes Juul Link naar reactie Delen op andere sites Meer opties om te delen...
Gast Geplaatst: 24 oktober 2003 Delen Geplaatst: 24 oktober 2003 Heb je de SAM-reset al geprobeerd ? Link naar reactie Delen op andere sites Meer opties om te delen...
Gast Geplaatst: 24 oktober 2003 Delen Geplaatst: 24 oktober 2003 Beste Erik, ja, heb ik geprobeerd : zilge ! Link naar reactie Delen op andere sites Meer opties om te delen...
Dishwasher Geplaatst: 26 oktober 2003 Delen Geplaatst: 26 oktober 2003 Hoi , Ik heb ooit ook zoiets gehad ,tijdens het laden via rs 232 is de verbinding vebroken , daarna kwam melding -01 / 03 hij zat nog steeds op signaal te wachten ,maar dat ging niet meer via de rs232 kabel. Het laden moest afgemaakt worden via de asta , maar mijn schotel stond niet 100% goed , dus bleef hij hangen op melding ...-03, schotel beter uitgericht en ..jawel hoor laden ging verder en alles draaide weer. Misschien kun je iets met dit verhaal Link naar reactie Delen op andere sites Meer opties om te delen...
Aanbevolen berichten
Maak een account aan of log in om te reageren
Je moet een lid zijn om een reactie te kunnen achterlaten
Account aanmaken
Registreer voor een nieuwe account in onze community. Het is erg gemakkelijk!
Registreer een nieuwe accountInloggen
Heb je reeds een account? Log hier in.
Nu inloggen